← hub ← calculators← kalkulator

circuit.

Pick a part, then drag on the grid from one dot to another to place it. Tap a part with ✋ edit to change its value (4k7, 100u, 10m) or flip a switch. Colours show voltage, moving dots show current. Pilih komponen, lalu seret di grid dari satu titik ke titik lain buat memasang. Tap komponen pakai ✋ edit buat ganti nilainya (4k7, 100u, 10m) atau membalik saklar. Warna = tegangan, titik yang bergerak = arus.

timewaktu

t = 0 s
speedkecepatan:

scopeosiloskop

How it solves: every dot that something is connected to is a node with an unknown voltage. Kirchhoff's current law at each node (current in = current out) gives one equation per node, plus one per battery saying "the voltage across me is V". That's nodal analysis, the same thing you do by hand for a circuit with three nodes, written as a matrix and solved thousands of times a second. Ground is 0 V; with no ground placed, the − side of the first battery is used.

Capacitors and inductors change with time, so time is cut into small steps. For one step a capacitor acts like a resistor of dt/C in parallel with a current source that remembers its last voltage (an inductor: L/dt and its last current). Solve, move time forward, repeat. Slow the speed down to watch an RC charge or an RLC ring.

  1. Load RC charging, press play, tap the switch with ✋: the probe traces 1 − e−t/RC. After one τ = RC it's at 63%.
  2. Thevenin check: read the load's voltage, then work out Vth and Rth by hand and see if you agree.
  3. Wires are ideal-ish (1 µΩ). Short a battery with a wire and see what the current does.

Cara ngitungnya: setiap titik yang tersambung sesuatu adalah node dengan tegangan yang belum diketahui. Hukum arus Kirchhoff di tiap node (arus masuk = arus keluar) memberi satu persamaan per node, plus satu per baterai yang bilang "tegangan di aku = V". Itu analisis nodal, sama dengan yang kamu kerjakan manual buat rangkaian tiga node, cuma ditulis sebagai matriks dan diselesaikan ribuan kali per detik. Ground = 0 V; kalau nggak ada ground, sisi − baterai pertama dipakai.

Kapasitor dan induktor berubah terhadap waktu, jadi waktunya dipotong jadi langkah-langkah kecil. Untuk satu langkah, kapasitor bertingkah seperti resistor dt/C paralel dengan sumber arus yang mengingat tegangan terakhirnya (induktor: L/dt dan arus terakhirnya). Hitung, majukan waktu, ulangi. Pelankan kecepatannya buat melihat RC mengisi atau RLC berosilasi.

  1. Buka RC mengisi, tekan play, tap saklarnya pakai ✋: probe menggambar 1 − e−t/RC. Setelah satu τ = RC nilainya 63%.
  2. Cek Thevenin: baca tegangan beban, lalu hitung Vth dan Rth manual dan cocokkan.
  3. Kabelnya hampir ideal (1 µΩ). Coba short-kan baterai pakai kabel dan lihat arusnya.